Remotec ZXT-310 V1.2 - Manual (Page 12)

12
IR Output Power
Set IR Output Power Level for each IR port (except IR Port 1)
L Important
− Please make sure that the “End point selection control” has
completed (if necessary) before process the following setup.
Step Setup Key
LED Indication
Status on
ZXT‐310
1
Make sure ZXT‐310 switched to
Channel 1 (EP1) • LED flashes
once then
keep on
2
Refer to your primary controller
instructions to process the
configuration setup procedure.
‐ Parameter: 28 (0x1C)
‐ Value: 255 (0xFF)
Set IR output power level by entering
0 (0x00) Normal power mode
255 (0xFF) High power mode
(default is in high power mode)
‐
3
Press the PROG button on
ZXT‐310 • LED flashes
twice then
keep on
• Set IR Power
level
successful
Note 1: Red LED flashes 6 times means that the setup process is failed.
Please redo the process again.
Note 2: IR port 1 is a fixed IR output power which is un-configurable
and operating in wide angle and long distance coverage.