RGBLink VENUS X2 User Manual - Manual (Page 33)

4. Menu Orientation
MENU
VENUS X2 User Manual 33
SYSTEM
Push the [MENU] button to go into the menu items, turn the knob button to
select <SYSTEM>, show menus as follows:
SYSTEM INFO: Show the serial number, version and tech support
information, shown as follows:
SN: Show the serial number of the device.
VERSION: Show the version of input board, output board, COM board and
KEYPAD.
TECH SUPPORT: Show the factory sales, after sales, email and other
contact information, etc.
DATE&TIME: User can view and change the date and time, view the
current time, last time, total time and boot times.
ETHERNET: Network and DHCP setting, include IP address, subnet mask,
gateway and WIFI setting. System default IP address is 192.168.0.100,
subnet mask is 255.255.255.000, gateway is 192.168.000.001.
User can enable or disable the WIFI function. When choose ―ON‖, choose
the WIFI mode, user can choose STA or AP mode, and then scan the
network.
FAN CONTROL: User can able or disable the auto speed function, and set
the current speed.
INPUT ADJUST: Adjust the input signal, sub menu as follows:
PORT: Choose the input port.
H POS: Image horizontal position.
V POS: Image vertical position.
CLOCK: Input signal clock.
PHASE: Input image phase.
Note
Only comments to professional operator.