Seaward 100 PrimeTest - Manual (Page 14)

PrimeTest 100 Operating Instructions
12
• The unit will proceed with the Insulation and
Leakage
tests.
Note:
The power switch on the appliance
under must be in the ON position to
perform an insulation test. If no
appliance is detected the PrimeTest
100 will display the following.
• Check that the appliance power switch is in the
ON position. The test will automatically proceed
if the appliance power switch is placed in the
ON position.
• If the LO LOAd enunciator remains on the
display, the load presented by the appliance
may be too small for the PrimeTest 100
to detect. In this case, press the test key
to continue.
• If the Insulation Resistance is greater than the
factory set limit a tick is placed next to the Riso
enunciator. If the Leakage current is less than
the factory set limit a tick is placed next to the
I
LEAK
enunciator.
• The PASS enunciator is illuminated.
2