Skutch Electronics CK-2 - Manual

Page 1 of 5
"Telecommunication Products to solve Telecommunication Problems"
CK-2
Promotion-On-Hold Module
(For GE 29487GE2 and 29488GE2)
Introduction
Thank you for purchasing
the Skutch CK-2 Promotion-
On-Hold Module for the
GE 29487 and 29488 four
line telephones. The CK-2
supplies Promotion-On-
Hold whenever any call is
placed ON HOLD with the
telephone's hold button. The
CK-2 not only supplies
Promotion-On-Hold, but it
also removes the annoying
"BEEPS" that these
telephones produce every 3
seconds when the phone is
placed on hold. The CK-2
will supply Promotion-On-Hold to callers that are placed ON HOLD ONLY from the
GE 2-9487 or 2-9488 telephones. Other makes and/or models of telephones can be used
with the CK-2 but they will not produce Promotion-On-Hold when placed ON HOLD.
Installation
There are two methods that can be used to install the CK-2 module. It basically depends
on how close the telephones are together. If all of the telephones are within 25 feet of a
central point, then method #1 can be used. In this case modular cords MUST be run
directly from the CK-2 box to each of the telephones. If your telephones are spread out
more than 25 feet apart, then you will need to use method #2. In this case you will have
to have a qualified person install four telephone jacks in front of your all of your
telephones. The CK-2 will have to be connected to these jacks. In this case the wiring to
the telephones remain unchanged. See method #2 for more details.
Modular Cords
Power Cube
Audio Cord