Skutt Firebox 8 - Manual (Page 4)

4
4
Location
1. Locate your kiln near an existing electrical outlet or where a new circuit can be installed with the least cost. Position the
kiln to the left of your electrical outlet so the cord will have an easy run and will not place a strain on the plug or outlet.
2. Install it in a well ventilated, sheltered area such as a carport, garage, utility or hobby room. It should be convenient to
where you are working, and out of the way of traffic areas.
3. Allow at least 18” (46 cm) of space between your kiln and adjacent walls.
4. Do not locate the kiln where flammable materials will be stored.
5. Never fire your kiln within a four sided cabinet or closet. The fourth side must always be open to room air to prevent
the kiln from overheating surrounding surfaces. .
6. The kiln must be placed on a non combustible surface such as cement, brick, metal or ceramic.
7. When installing a kiln in a room with a fire control sprinkler system, please check the sprinkler head rating to insure that
heat emitted from the kiln will not activate the sprinkler system.
Preparation Before Firing
u
npack
k
iln
Once you have located a spot for your kiln it is time to unpack it and set it up. Below is a list of all the components that
should be included:
K
iln
s
eTup
Fire Box Kiln •
Stand •
Pyrometer •
Goodie Bag Contents
Thermocouple Flange •
2 Screws •
Warranty Card •
Glass Kiln Catalog •
FireBox Manual •
If there are any items missing or you notice any freight damage contact your distributor immediately. Freight compa-
nies will not honor claims if too much time has passed from the time the item was received. You will notice that the seams
between the brick will be missing mortar in certain areas. This is normal and will not affect the performance of the kiln.
Mortar is intentionally left out of the seams near the elements so it will not come in contact with the element itself.
Remove the stand from the box and place it where you have chosen to locate your kiln. The stand should be oriented so
the channels are on the sides. Place the kiln on top of the stand and center it. Make sure the switch is set to the off position
and plug the kiln into the receptacle. Make sure the receptacle is wired to the correct amperage breaker and the proper gauge
wiring has been installed. See the Electrical Specifications section for electrical installation guidelines.
Optional Accessory Kit
Three 1” Shelf posts •
One - 7” x 7” x 1/2” •
Square Shelf
8 oz. Kiln Wash
•
Fiber Paper •
V
acuuM the
k
iln
Often times during shipping brick dust will accumulate in the element grooves and on the bottom of the kiln. We recommend
that you vacuum the inside of the kiln to remove any dust that accumulates during shipment.
p
riMe
k
iln
S
helVeS
You will want to apply a shelf primer, also referred to as kiln wash, on your kiln shelf (purchased separately) to protect it
from melted glass adhering to it. There are a number of different formulations with different instructions for application so
be sure to follow the directions of the brand you choose. Be sure newly coated shelves are dry before firing them in the kiln.