Skutt EnviroVent 2 - Manual (Page 4)

4
44
s
eTup
S
tandard
E
nviro
v
Ent
2 i
nStallation
This section of the manual covers standard installations of The EnviroVent 2 on a single top loading, multi-sided,
electric kiln with a chamber size under 12 cubic feet. A Dual Intake Kit is available for venting a single kiln over
12 cubic feet or two kilns with chamber volumes each at or under 12 cubic feet. The maximum chamber volume
that can be vented with one motor is 24 cubic feet. For instructions on venting two kilns, kilns greater than 12
cubic feet and other custom installations consult the Custom Installations section of this manual.
As with any change in firing routine, we recommend that you closely follow all instructions and monitor your fir-
ings with witness cone groups on each shelf of your kiln both before and after you install the EnviroVent 2. If you
have any questions, please contact your supplier.
EnviroVent 2 Contents
Blower Motor w/6 ft. Power Cord w/In-line Switch
8” x 12” Mounting Plate
8 ft. x 3” Flexible Aluminum Duct
Spring Loaded Plenum Cup Assembly
Cast Plenum Cup
Fiber Gasket
Plenum Stand w/Base
Plenum Spring
Blower Inlet Tube
Blower Discharge Tube
3” to 4” Connector
Floor Mount Plate
Operating Manual
Mounting Hardware
4 - #10 x 1 ½” Sheet Metal Screws
4 - 8-32 x ¼” Screws
4 - 8-32 Lock Washers
4 - 8-32 Hex Nuts
4 - 1/8” x 2” Toggle Bolts
1 - 1/4” twist drill
1 - 3/16” twist drill
2 - Hose Clamps
Clamp
Hose
Typical Installation
Envirovent 2
w/Switch
Cordset
115 volt
3" x 8" Discharge Tube
W/Motor
Blower
Clamp
Hose
With Spring
Cup Stand
Cup
Plenum Tube
Flex
3" Diameter
in Wall
3 1/8" Cutout
Hood
Rain
Necessary
Cut as