Desa BY150ECB 150,000 Btu/Hr 110v/50 Hz - Manual (Page 3)

3 104001
OWNER’S MANUAL
PRODUCT
IDENTIFICATION
Figure 1 - Model BY150ECB
These models are furnished with wheels and
a front handle. Some models are furnished
with a rear handle also. Wheels, handle(s),
and the mounting hardware are found in the
shipping carton.
Tools Needed
• Medium Phillips Screwdriver
• 3/8" Open or Adjustable Wrench
• Hammer
1. Slide axle through wheel support
frame. Install wheels on axle.
IMPORTANT: When installing
wheels, point extended hub of wheels
toward wheel support frame
(see Figure 2).
2. Place cap nuts on axle ends. Gently tap
with hammer to secure.
3. Place heater on wheel support frame.
Make sure air inlet end (rear) of heater
is over wheels. Line up holes on fuel
tank flange with holes on wheel sup-
port frame.
4. Place front handle and rear handle on
top of fuel tank flange. Insert screws
through handles, fuel tank flange, and
wheel support frame. Attach nut finger
tight after each screw is inserted.
5. After all screws are inserted, tighten
nuts firmly.
ASSEMBLY
Front Handle
Rear Handle
Wheel
Support
Frame
Wheel
Extended
Hub
Hot Air
Outlet
Fuel
Tank
Flange
Screw
Nut
Cap Nut
Axle
Air Inlet
Figure 2 - Wheel and Handle Assembly
Hot Air
Outlet
Upper
Shell
Flame-Out
Control Reset
Button
Fan Guard
Fuel Tank
Power Cord
ON/OFF
Switch
Fuel Cap
Lower
Shell
Side Cover