SONOSAX SX-R4 User Manual - Hardware Description - Manual (Page 11)

SONOSAX SX-R4 User manual / Hardware description Page 11 of 19
4.2.7 Time Code Connector [ TC ]
The TimeCode input/output connector is a Lemo 5 pin, compatible with the Aaton wiring as below:
Pin 1 = Gnd
Pin 2 = Smpte Out
Pin 3 = not connected
Pin 4 = not connected
Pin 5 = Smpte In
The mating cable connector Lemo 5 pin is available by SONOSAX or by your local dealer under ref part
SONOSAX SX-860232 or Lemo FGG.0B.305.CLAD52
4.2.8 Digital Input [ ACCESSORY ]
This 26pin connector provides 4x AES/EBU digital audio inputs [AES1 to AES4]. The sync signals such as
the Sync In and the Wckl Out, the Time Code In and Out and the Monitor Out are internaly wired in paralel to
the corresponding main connectors. The serial bus is provided for future use
The mating cable connector is available under SONOSAX ref: SX-860570
Split cables wired for the 4x AES inputs are also available, please check with your local dealer.
4.2.9 USB2 connector [ USB ]
This connector is of USB2 type only. The SX-R4 is not compatible with ancillary USB 1.0 system
It allows to connect the SX-R4 to any computer ( PC or Mac ) providing with a standard USB2 port. As soon
as connected, the SX-R4 will appear on the computer desktop as an external Hard disk drive. If a Compact
Flash card is inserted, it will also appears on the desktop.
WARNING: It is highly recommended to use a Certified "USB 2 High Speed" cable. The data rate
transmission is so high that using a non certified cable may lead to unpredictable malfunctions
such as : Disk not recognized, SX-R4 nor appearing on your desktop, Windows error code 10
etc etc