SONOSAX SX-R4 User Manual - Hardware Description - Manual (Page 9)

SONOSAX SX-R4 User manual / Hardware description Page 9 of 19
4.2 RIGHT SIDE PANEL
This panel contains followings connections:
• Headphone output [PHONES] on a ¼" jack
• Unbalanced stereo/dual-channel Line input [STEREO IN] with adjustable sensivity
• Unbalanced stereo/dual-channel Line output [SUB OUT] with adjustable output level
• External Video or Wordclock sync input [SYNC IN] and Wordclock output [WCKOUT]
• Digital Input AES 1 to AES 4 on a 26 pin multiway connector
• TimeCode input/output [TC] all format on a 5 pin Lemo
• External 6 to 18 Volts DC power supply [DC IN] on a 4 pin Hirose
• USB2 high seed connector [USB] for connection to any computer
• CompactFlash card slot
NOTE:
The mating cable connector for the [STEREO IN] and the [SUB-OUT] a TA-3 female.
It is available under SONOSAX part nr SX860266 or Swtichcraft TA3FX
4.2.1 Headphone output [ PHONES ]
The headphone output on a 6,25mm ( ¼" ) jack allow connection of any mono or stereo headphone having
an impedance greater than 30 ohms
.
The headphone level is adjustable by the Joystick ( see chapter 5.1.3 ). Pressing the Joystick to the left will
decrease the volume, pressing the Joystick to the right will increase the volume. The volume control is only
possible while in REC Mode or in PLAY mode.
The combination of tracks to be monitored and the monitoring mode is set in the [MONITORING] menu. It is
also possible to listen to each track individualy (mode SOLO , chapter 5.1.5)
The headphone connector [PHONE] is a stereo jack 6,35mm ( 1/4" ) where:
Sleeve = Gnd / Ring = Right / Tip = Left
WARNING:
the headphone amplifier of the SX-R4 is quite powerful. It is recommended to set the
headphone level for a reasonable loudness to protect your precious ears