Spectec SDV-841/842 - Manual (Page 8)

Pocket PC for reading eBooks. You could create a configuration named
"eBook Reading" with default width and height and rotated into a
landscape orientation. Another example might be web browsing. Most
web sites require a minimum horizontal resolution of 640 pixels in order to
display their content properly. You could create a configuration named
"Web Browsing" with a width of 640, height of 480 and rotated into a
landscape orientation. You might then choose to compress the virtual
display to fit the physical display allowing you to view the entire 640x480
page on your 320x240 display without panning.
The NVD setup program creates a number of sample configurations and
schemes to give you some ideas. You may modify, copy or delete any of
these configurations/schemes or you may create entirely new ones of
your own. There a two special virtual display configurations. The first,
"(Disable Virtual Display)" should be selected when you do not wish to
use any of NVD's features. This configuration restores your device's
video properties to their factory values. The second, "(Current
Configuration)" simply resets all of the properties to those of the current
virtual display mode, in case you change you mind and what to get back
where you started. The third, "(Standard Configuration)" sets the
properties to mimic those of the nominal factory settings. NVD is NOT
disabled in this case. Similarly there are two special schemes. "(Current
Scheme)" resets all of the properties to the current values for the system.
"(Standard Scheme)" restores your device to its factory color and font
properties.
Modifying Virtual Display Properties
The various properties for the virtual display configuration are organized into
five separate tabs. To modify and apply virtual display properties, follow the
steps below. Although it is not required, if you use the same property values
repeatedly you should save them to a named configuration .
1. Start the Virtual Display Settings Applet .
2. Select the Configuration Tab.
3. If you have already created a named configuration and wish to use it,
select the name from the Configuration drop down list. Selecting the