Dish Network Platinum Plus 121150 - Manual (Page 11)

121150 9
For AUX mode, the first group of flashes tells you what the
AUX mode controls. A quick flash (zero) before the three-digit
code is for a TV; one regular flash is for a VCR; and two flashes
is for a tuner, amplifier, or cable box. For example, if the TV
code is 570, the
AUX mode button flashes once quickly, pauses,
flashes five times, pauses, flashes seven times, pauses, and
flashes once quickly.
C HANGE THE A DDRESS
Because UHF signals travel long distances and go through walls,
a neighbor’s remote may control your receiver by mistake. To handle
this problem, you can change the remote control and receiver address.
1. Open the Important System Information screen.
Press the receiver’s front panel SYSTEM INFO
button.
The
Important System Information screen shows
a Remote Address .
Write down this number:
2. Press and hold the SAT mode button about three
seconds, until all the mode buttons light up,
and then let go of the
SAT button. The SAT mode
button will blink.
3. Use the number buttons to enter any number
from 1 to 16, but not the one you found in step 1. The SAT
mode button goes out after you enter each digit, and then lights
up again.
Write down the number you entered:
4. Press the POUND ( # ) button.
If you entered the address correctly, the SAT mode
button will flash three times.
5. Press the RECORD button.
6. Make sure the Remote Address on the Important
System Information screen now is the same as the
one you entered in step 3. If it isn’t, the remote can’t
control the receiver.
text_dishpvr.fm Page 9 Tuesday, January 28, 2003 8:04 AM