Dish Network Platinum Plus 121150 - Manual (Page 9)

121150 7
7. Press the POUND ( # ) button. If you entered the code
correctly, the mode button flashes three times.
8. Press the blank POWER button to test if the code
works for the device. If it does, the device should
turn off.
9. Turn the device back on and try some other buttons
to make sure they work. Sometimes, the blank POWER button
works when other buttons don’t. If the code works for other
buttons, stop here.
10.If the code you entered doesn’t work, do steps 3 through 9 again
with another device code from the tables.
11. If you cannot find a code that works, try Scan for Device Codes
below.
S CAN FOR D EVICE C ODES
If the code for your device is not listed in the tables on starting page 26,
use this procedure to scan the remote control’s memory for the device
code. Here’s what to do:
1. Use the device’s buttons or its remote control to turn the device
on.
2. Press and hold the mode button for the device you want the
remote to control, for about three seconds. When all the other
mode buttons light up, let go of the mode button - that mode
button should now be flashing.
For example, hold the TV mode button for a TV until all of the
other mode buttons light. When you let go, the TV mode light
will flash.
3. Only for the AUX mode, use the number buttons
to enter 0 for a second TV, 1 for a second VCR,
or 2 for a tuner, amplifier, or cable box. Then press
the STAR (*) button.
For any other mode, skip to step 4.
text_dishpvr.fm Page 7 Tuesday, January 28, 2003 8:04 AM