Desa Ga3750a - Manual (Page 6)

108319-01B
6
For more information, visit www.desatech.com For more information, visit www.desatech.com
5. Attach the power cord to the blower motor by firmly pushing
the two female terminals at the end of the power cord onto the
two spade terminals on the blower motor.
6. Attach green ground wire from power cord to blower housing
using screw provided (see Figure 16). Tighten screws securely.
7. Place the blower on the mounting bracket with the exhaust
port directed upward. Align the holes in blower frame with
holes in bracket (see Figure 16). Using 4 screws provided mount
blower and tighten each screw.
8. Be certain that all wire terminals are securely attached to ter-
minals on blower motor and that the screw retaining the green
ground wire is tight.
9. Reattach motor mounting bracket using screws removed in step
1, page 5.
10. Plug in power cord. This blower is supplied with a 3-prong,
grounding plug. It must be plugged into a standard 3-prong
grounded wall outlet near the stove.
11. Check to make sure that the power cord is completely clear of
the blower wheel and that there are no other foreign objects in
blower wheel. Turn blower on and check for operation. Turn
blower off by rotating knob fully counter-clockwise before
continuing.
INSTALLING BLOWER
ACCESSORY IN MODEL SVFBC
FREESTANDING STOVE
Continued
12. Peel off the backing paper and stick the supplied wiring dia-
gram decal on the back of the blower mounting bracket (see
Figure 13, page 5).
Note: Discard the remaining hardware items.
CAUTION: Never touch the blower wheel while in
operation.
Figure 16 - Attaching Blower to Mounting Bracket
Blower
Mounting
Bracket
Screws Exhaust Port
Ground
Wire
OPERATING THE BLOWER
Light your gas appliance with the blower off. After about 15 minutes, turn
the blower on to deliver heated air at the top louvers. The blower features
a variable control which allows you to select the speed you desire.
INSTALLING BLOWER
ACCESSORY IN 32"
FIREPLACE SYSTEMS
NOTICE: Shut off gas supply and disconnect heater
from gas supply. Contact a qualified service person
to do this.
Note : Appearance of firebox or burner system may vary depending
on model.
1. Remove fireplace screen per the instructions in operation
manual supplied with fireplace.
2. If logs are installed, carefully remove the logs and set aside,
noting the properly mounted location of each.
3. Remove screws that attach log base assembly to fireplace. Care-
fully lift up log base assembly and remove from fireplace, tak-
ing care to pull flexible gas line through the access holes (see
Figure 17).
CAUTION: Do not pick up log base assembly by
burners. This could damage burners. Only handle
base by grates.
Figure 17 - Removing Log Base from Fireplace
4. Attach the power cord to the blower motor by firmly pushing the two
female terminals at the end of the power cord onto the two spade
terminals on the blower motor.
5. Attach green ground wire from power cord to blower housing us-
ing screw provided (see Figure 18). Tighten screws securely.
Figure 18 - Mounting Blower to Firebox
Screws
Log Base
Flexible
Gas Line
Blower
Screws
Top Mounting Tab
Exhaust Port
Screw
Green
Ground Wire
Lower Rear
Wall of
Firebox
INSTALLING BLOWER ACCESSORY IN MODEL SVFBC FREESTANDING STOVE
INSTALLING BLOWER ACCESSORY IN 32" FIREPLACE SYSTEMS