Sundance SMT300Q v.1.6 - Manual (Page 50)

User Manual (QCF42); Version 3.0, 8/11/00; © Sundance Multiprocessor Technology Ltd. 1999
15 Stand-Alone Mode
For the SMT300Q to operate in stand-alone mode Jumper J8 (Figure 14 : Jumper
Finder Diagram) must be installed and the Auxiliary power header (J1) connected.
The plug for the power connector is AMP part N
o
640440-8. The connector requires
wiring as shown in the pin diagram below. Wire of 0.3 mm
2
core (22 AWG) should be
used.
Figure 12 : Auxiliary Power Connector
1
2
3
4
5
6
7
8
1) +12V
2) -12V
3) +5V
4) +5V
5) +3.3V
6) +3.3V
7) GND
8) GND