Sundance SMT6001 - Manual (Page 10)

4. Dynamic Settings
The bootloader can perform up to eight assignments of 32-bit values to memory
locations at absolute addresses. This facility is usually only needed in unusual
circumstances, such as to modify the internal comport connections on some multi-
processor TIMs.
These assignments are made immediately after the FPGA has been configured but
before any user code is loaded.
4.1 Adding a Dynamic Setting
Press "New" under "Dynamic settings". This will bring up the following window:
Type in the required address and value, then press "OK".
4.2 Removing a Dynamic Setting
Select the setting to be removed and press "Delete" to the left of the list of current
settings.