Super Systems AC20 User Manual

Page 43

Advertising

C.I06 -

C.I06 - Set point display type

Set point display type

Upper display: CnF.6
Lower display: SP.dS
Range: Fn.SP = When device is in normal display mode and it is

performing a set point ramp, the middle display
will show the final set point value.

OP.SP= When device is in normal display mode and it is

performing a set point ramp, the middle display
will show the operative set point value.

C.I07 -

C.I07 - Burn Off and Purge activation threshold

Burn Off and Purge activation threshold

Upper display: CnF.6
Lower display: t.t.Ac
Range: the instrument will start the Burn Off and the Purge

procedure according with the following selection:

No = without testing the temperature limit (1000 °F)
YES= if the temperature test is satisfy.

Available::::: When mV is selected as primary control variable.

C.I08 -

C.I08 - Time out selection

Time out selection

Upper display: CnF.6
Lower display: t.out
Range: tñ.10 = 10 s time out

tñ.30 = 30 s time out

CONFIGURATION GROUP [C.Lxx]

CONFIGURATION GROUP [C.Lxx]
INPUT/OUTPUT TEST

This group is displayed only when configuration modify mode is
enabled.
This group allows you to verify the correct working of:
- the relay outputs (OUT 1 up to OUT5),
- digital inputs (diG.1 up to diG.3),
- the inputs from In1 up to In8 and the relays of the outputs from

OUT10 up to OUT19, if the optional I/O card is fitted.

When an output is in "On" status, the related LED will light up
(for OUT 5 is used the "ST" LED)

C.L01 OUT 1 status

C.L01 OUT 1 status
Upper display: VErF
Lower display: OU.1
Range: On

= Output enabled (relay energized)

OFF

= Output disabled (relay deenergized)

Advertising