Digi 62533 - Manual (Page 3)

TB-6128 Page 3 of 7 Revision 10/06
© 2005 DESCO INDUSTRIES INC.
Employee Owned
Packaging:
• 1 - Digi SP One Ethernet Adapter
• 1 - Diagnostic Loop Back Key
• 1 - Quick Start Guide
• 1 - Release Note
• 1 - Installation and Drivers CD-ROM
• 1 - 100 ~ 240 V to 12VDC Power Adapter
• 1 - 24” Inverted Communication Cable
• 1 - 4 pcs Universal Power Plugs
Note: Ethernet cable is not supplied with unit. End user must supply his or her own Ethernet cable.
System and Hardware Requirements:
• Designed to be used with Smartlog X3 systems
50440 - SmartLog X3 w/Dual Foot Plate, Keypad, & Barcode Reader, 120V
50441 - SmartLog X3 w/Dual Foot Plate, Keypad, & Barcode Reader, Euro Specs
50442 - SmartLog X3 w/Dual Foot Plate, Laser Scanner, Euro Specs, CE Approved
• Smartlog 6.03 software, TEAM Enterprise Software or TEAM Basic Software
Mounting and Installation:
NOTE: If existing model 50460 Ethernet adapter is used, model 50461 cannot be used on the same LAN due to
driver conflicts. We highly recommend switching over to model 50461 Ethernet adapter.
This technical bulletin is intended for personnel familiar with networking concept and Smartlog X3 systems.
Before mounting of the Ethernet adapter to wall or back-plate of Smartlog X3, Ethernet adapter unit must be, configure
with the correct communication parameter and be assigned an IP address.
1. Powering unit and Locating unit on the LAN
Make sure there is an Ethernet cable, LAN jack and power outlet for the Ethernet card to connect to.
Figure 2.
Before powering or connecting Ethernet
cable, refer to Figure 2. dip switch must be
set to dip 1 to the on position (up) and the
rest off (switch 2 to 4 down, MFG default)
and the diagnostic loop back key must be
securely connected to serial (DB9 male)
port. Make sure the AC power adapter
supplied with model 50461 is used. The
AC power adapter is a 100 ~ 240VAC auto
switching power adapter and can be
plugged into any power outlet known with
the 4 piece universal plugs.