5 power connections, 6 block diagram, 1 - introduction to the da-40 – Teac DA-40 User Manual
Page 8
Advertising
1 - Introduction to the DA-40
TASCAM DA-40
8
WARNING
Do not attempt to use the tape deck with any
remote control unit except one designed
especially for use with this tape deck.
The
CONTROL I/O
connector is for use with suit-
ably-equipped control units (see
1.5.5 Power connections
Make sure that your AC voltage supply matches the
voltage requirements of the tape deck (as printed on
the rear panel).
1.6 Block Diagram
Advertising