Teac DM-24 New features - Manual

TASCAM DM-24 Version 2.1 Release Notes
1
New features in DM-24 version 2.1
Buss assignment
Busses 1-8 can now be assigned to the stereo buss on
the
ASSIGN page, the MODULE page and also using the
ASSIGN section key.
Bear in mind that like EFFECT 1-2 , DIGITAL IN 1-2 and
ASSN RETURNS 1-4 , these signals enter the stereo buss
after (post) the Master Comp Insert Matrix.
The result of this is that if you are compressing the
stereo buss, these signals assigned to the stereo buss
are not affected by the compressor.
However, if the ASSIGNABLE sends and returns are
used as stereo buss INSERTS , these inserts will affect
the signals sent to the stereo buss. Any analog inserts
used on the stereo buss will also affect these signals.
1 To assign these signals directly to the stereo
buss, use POD 4 to move the cursor to
ST in
the upper right of the ASSIGN page.
2 Then use the SEL key of the buss, or the cur-
sor keys or the dial to highlight the item you
wish to assign and press the
ENTER key.
This assignment can also be made in the buss
MODULE page.
To assign busses 1-8 to the stereo buss using the
STEREO key in assign section:
1 Select the busses 1-8 using the SEL keys.
2 Then press the STEREO key in the assign sec-
tion. Busses 1-8 are assigned to the stereo
buss directly (this can be confirmed on the
MODULE page).
Buss signals assigned to the stereo buss fol-
low the
Balance Level CENTER: 0dB setting on the
OPTION-PREFERENCES page.
9101449300