Teac DP-01 Series Quick Start - Manual (Page 2)

03/01/05 Pa
g
e
2
of
4
DP-01 / DP-01FX Quick Start Guide
Using the Reverb Effect (DP-01FX)
T he DP-01FX has a dedicated Reverb effect that’s
available to all tracks. Each channel has an Ef-
fect Send knob so that you can control the amount
of reverb – lots of reverb for the drums, a little on
the vocal, etc. Here’s how you set that up.
1. If the REVERB light is not on, hold the SHIFT
button and press REVERB.
2. Let go of the SHIFT button and press REVERB
again. The LCD window will show you what
reverb type is selected.
3. Turn the TYPE knob to change to a different
reverb type: Hall, Room, Live or Studio.
4. Turn the PARAMETER knob to change the decay
time of the reverb for a larger or smaller-sound-
ing space.
5. Send your recorded tracks to the reverb proces-
sor using the EFFECT SEND knobs above those
channel faders and adjust the overall level of
the external effect using the EFFECT RETURN
knob.
Using the Multi Effect (DP-01FX)
T he DP-01FX has two effects processors. The
Multi effect processes the input as it’s recorded
to disk, while the Reverb effect is only for the mix-
down and only gets recorded when you master your
song. This section explains how to use the Multi:
1. Plug a guitar or other sound source into one of
the front-panel inputs.
2. Set the INPUT MODE switch on the front panel
to MONO.
3. While holding SHIFT, press the MULTI button.
The LED next to the button will show whether
the effect is processing the A input, B input or
neither one.
4. Let go of the SHIFT button and press MULTI
again. The LCD screen will show you what ef-
fect program is selected. The fi rst line shows
the name of the program (“CoolPick”), and the
second line shows what instrument it’s designed
for (“EGTR”).
5. Turn the TYPE knob to change to a different
effect program.
6. Turn the PARAMETER knob to change the sound
of that program.
Using External Effects
I f you have a reverb or multieffects processor, you
can plug it into the DP-01 to use in your mix.
1. Plug the SEND on the rear panel of the DP-01
into the input of your effects processor.
2. Plug the outputs of your effects processor into
the RETURN inputs of the DP-01.
3. Set the Mix control on your effects processor to
100% wet.
4. [DP-01FX only] Turn off the internal reverb pro-
cessor by holding the SHIFT button and pressing
the REVERB button (the light will go out).
5. Send your recorded tracks to the effects proces-
sor using the EFFECT SEND knobs above those
channel faders.
6. You can adjust the overall level of the external
effect using the EFFECT RETURN knob.
6
5
4