Teo 8030X User Manual

Teo Equipment

Advertising
background image

13-280109 Rev. A

September 2005

The Model 8030X Button Expansion Module adds an additional 30 multifunction keys to a Tone
Commander 8610, 8620, or 8810 ISDN telephone.

The following items are included with each 8030X:

(1) Model 8030X Button Expansion Module

(1) double-width mounting stand

(3) mounting screws for attaching to the telephone

(1) ribbon cable with ferrite filter

(1) key label sheet

(2) key label overlays

(1) Installation Instructions (this manual)

Button Expansion Module Installation

1. Disconnect the line cord.

Power must be disconnected before installing the 8030X.
Wait 10 seconds after disconnecting power before proceeding.

2. Press the telephone stand down to disengage the snap tabs, then lift off the stand.

The low desktop stand position is shown; the removal procedure is the same for high desktop
and wall mount positions.

3. Remove the Phillips screw from the center of the expansion cover. Press the back edge in to

release the retention snap, and tilt the top edge of the cover away from the telephone as shown
to remove the cover.

Your telephone may have an 8001TA, 8002TA, or 8003TA Terminal Adapter installed in place of
the cover.

8030X

Button Expansion Module

Installation Instructions

Advertising