Teo 6030X Button Expansion Module - Manual

13-102866 Rev. C
November 2006
The Model 6030X Button Expansion Module adds an additional 30 multifunction keys to a Tone
Commander 6210/6220 ISDN telephone or 7210/7220 VoIP telephone. Included with the 6030X are a
wider telephone base that replaces the standard base, a ribbon cable for connecting the 6030X to the
telephone, a key overlay, and one mounting screw.
Telephone operating software must be version 01.04.xx or higher (6210/6220) or 01.02.xx or higher
(7210/7220/7310/7320) to enable the Expansion Module. To view the installed software version, select
VERS, then S/W from the Administration Options menu (Setup
→ ADMIN→ VERS→ S/W). If your phone's
software version is lower than the required version, call Tone Commander at (800) 524-0024 to request an
update.
Button Expansion Module Installation
1. Disconnect the line cord.
Power must be disconnected before installing the 6030X.
Wait 10 seconds after disconnecting power before proceeding.
2. Remove the retaining screw in the center of the base.
3. Press the top of the tall edge of the base to disengage the snap tabs, then lift the base from the
telephone body. Do not touch the expansion connector.
4. Lay the telephone and Button Expansion Module face down, with the Button Expansion Module to
the left (on the opposite side from the speaker and handset).
5. Plug the supplied ribbon cable into the connectors on the telephone and Button Expansion Module
as shown. The polarization tab on each plug must fit into the opening on the side of the connector.
6. Slide the ferrite core on the cable toward the phone connector as shown.
6030X Button Expansion Module
Installation Instructions