Tri Tool 214B ID Track Module - Manual (Page 12)

12
TRI TOOL INC.
92-1504 : Orig. 140627
Location of the Retaining Plates
Tighten the Spring Draw Rod, but leave enough travel to accommodate out of round
pipe.
Make sure the Travel Stop Set Screw is retracted back flush with the bottom of the
Spring Bracket.
Install the Tool Bits in the ID Tracking Module.
Install the Beveling Tool Bit with the cutting edge on the centerline of the pipe or
tube.
The Land thickness will be determined by the position of the Beveling Tool bit
in the slot.
Slide the Beveling Tool Bit up and down in the slot keeping the bottom of the Tool Bit
flat against the bottom of the slot.
Once the desired position has been achieved, then tighten all of the Set Screws
which make contact with the Tool Bit.
Hold Down
Screws (8 ea.)
Travel Stop Set Screw
Spring Draw Rod
Retaining Plates
Base Plate
Spring Bracket
Tracking Wheel
Wheel Bracket