Tri Tool 214B ID Track Module - Manual (Page 13)

13
Model 214B ID Tracking Module (IDTM) Kit
92-1504 : Orig. 140627
Install the Facing (Land) Tool Bit with the cutting edge to the outside of the Tool
Holder.
The Land width will be determined by the position of the Beveling Tool Bit in
the slot.
Slide the Facing Tool Bit up and down in the slot keeping the bottom of the Tool Bit
flat against the bottom of the slot.
Once the desired position has been achieved, then tighten all of the Set Screws
which make contact with the Facing Tool Bit.
Attach the proper power supply line to the Model 214B.
Check that the Air Supply (FRL) is installed and set properly.
Turn the Motor on and start cutting.
Beveling Tool Bit Installation
Beveling Tool Bit
Cutting Edge
Land
Thickness
Tool Bit Movement
Rotation