Datalogic Scanning Modem - Manual (Page 14)

STAR Modem™
6
UK/US
Position 1 = RS232/Digital interface
Position 2 = Wedge/Pen Emulation interface
STAR
Modem™ configuration can be performed in three ways: by using the
DL Sm@rtSet software configuration program, by sending configuration strings from
the Host via the RS232 interface or by reading configuration barcodes with a
Datalogic RF device and sending the commands to STAR
Modem™ via radio.
DL Sm@rtSet
DL Sm@rtSet is available on the STAR Modem™ CD-ROM and can be installed on
your PC.
DL Sm@rtSet is a Windows-based utility program providing a quick and user-friendly
configuration method via the RS232 interface.
It also allows upgrading the software of the connected device (see the DL Sm@rtSet
User's Manual for more details).
Configuration Strings
STAR Modem™ initial setup must be performed via serial interface by sending the
configuration strings to the modem using any terminal emulation program, for
example Hyper Terminal.
NOTE
Ensure that your PC COM port is set as follows:
9600 baud, no parity, 8 data bits, 1 stop bit, handshaking disabled.
The programming sequence is the following:
$+ Command $- CR
Enter configuration environment
Character sequence in following tables
Exit and Save configuration
Carriage return character (0D Hex.)
Position 1 Position 2
Screws