Upsite 10033 Blanking Panel – 2U - Manual (Page 4)

4 Designer & Manufacturer
(888) 982-7800 www.upsite.com
Installation Procedures for Tight Rails
1. Install one side of the blanking panel first and make sure it is seated against
the rail.
2. Grab the finger grip opposite the side that has been installed and apply slight
horizontal pressure. Push and snap in the blanking panel.
3. If the blanking panel is not seated properly in the rail, reach over the blank-
ing panel, grab the clip and push towards the middle of the cabinet. Apply
slight pressure and snap in the blanking panel.
4. In the event the flanges on the blanking panel get caught while trying to
insert the panel, squeeze the flanges and slightly press them in until you can
snap in the blanking panel.
5. In the event there is only a 1U opening without access to the top of the
blanking panel, using your thumbs, place slight pressure on the two clips
bending them in slightly (relieving the pressure ) and snap in the blanking
panel.
Install Images
1 2
3 4