Watson-Marlow Bredel 10 User Manual
Page 34
MAINTENANCE
34
2.
Fit the pump hose (A) via one of the ports.
3.
Let the motor run to let the rotor pull the hose in
the pump housing. Stop the motor when the
hose sticks out equally from both sides of the
pump housing.
4.
Check that the rubber bushes (A) are not
deformed or damaged and replace them if
necessary.
5.
Check that the hose clamps (B) are not
damaged and replace them if necessary.
6.
First fit the inlet port.
Slide the rubber bush (D) over the hose.
Push the bracket (A) and the hose clamp (B)
over the hose together. Align the holes in the
bracket with the ones at the front of the port.
Position the two retaining bolts (C) and tighten
them. Make sure the bolts are tightened with the
correct torque. Refer to §
WARNING
During jogging the drive:
-
Do not stand in front of the pump
ports.
-
Do not try to guide the hose by
hand.