Epson ELPD04 - Manual (Page 23)

18 Using the Document Camera
Turning On Your Equipment
Make sure your document camera and other equipment are set up and
connected correctly, as described in Chapter 1. Always turn on your
projector or monitor first. Then turn on your document camera, as
described below, followed by any other equipment you’ve connected
to it.
You can turn on your computer and video equipment in any order. If
you have both a computer and video source connected, you may have
to switch to the desired source to see its image, as described on
page 20.
Turning On the Document Camera
Follow these steps to plug in and turn on the document camera:
1. Connect one end of the power cord to the document camera’s
power inlet.
2. Connect the other end to a grounded electrical outlet.
3. Turn on the projector or monitor.
4. Turn on the document camera.
After a few moments, the upper lamps turn on.
5. Place your presentation material on the stage. You should see an
image on screen.
AC IN
RGB IN RGB OUT ON
OFF
RS-232C
POWER VIDEO
OUT
USB
0
1
A B C
power
inlet
AC IN
RGB IN RGB OUT ON
OFF
RS-232C
POWER VIDEO
OUT
USB
0
1
A B C
power switch
elpdc04.book Page 18 Tuesday, February 12, 2002 8:32 AM