Epson ELPD04 - Manual (Page 51)

46 Notices
Remote Control Information
You can operate the document camera by remote control via a line-of-sight
infrared (IR) receiver at the front and rear of the document camera. The
document camera may not respond to remote control commands under the
following conditions:
■ There is an object between the remote control IR emitter and the IR
receiver on the document camera.
■ Ambient light is too bright.
■ Certain types of fluorescent lighting are used.
■ A strong light source shines into the IR receiver.
■ Other equipment that emits infrared energy, such as a radiant room
heater, is in the room.
These conditions commonly cause problems for most infrared-controlled
equipment. Try the following:
■ The remote control batteries may be low on power; replace them.
■ Dim the ambient lighting and/or turn off any fluorescent lights.
■ Close any window coverings and/or move the document camera out of
direct sunlight.
■ Turn off other equipment that emits infrared energy.
If the remote control still does not work properly, you can always use the
buttons located on the document camera control panel, even in an
environment containing one of the conditions listed above.
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS PRODUCT TO
RAIN OR MOISTURE.
THIS IS A CLASS B PRODUCT. IN A DOMESTIC
ENVIRONMENT THIS PRODUCT MAY CAUSE
RADIO INTERFERENCE IN WHICH CASE THE USER
MAY BE REQUIRED TO TAKE ADEQUATE
MEASURES.
elpdc04.book Page 46 Tuesday, February 12, 2002 8:32 AM