Watson-Marlow MC12 - Manual (Page 23)

Operators and Reference Manual
MC12
MC12 OM RM 1.03_EN Version: 1.03 Date: 2010-11-17 Page 23 of 46
If the number is occupied by a program already saved, the system will ask:
“OVERWRITE PGM. (Y/N)”
If <Y> is pressed, the old program is deleted and the new program is saved with this number.
If <N> is pressed, the system will go back to the position from which a new program number can
be selected.
Select a new program number and press <ENT> to confirm this new number.
The old program saved under the number originally suggested will be kept and the program will
be saved under the new number.
If program number 0 is selected, the function is left without saving the program.
6.7.26. Function 32 - Load program
This function loads a program already saved and overwrites the current parameters with the
values of the program.
When pressing <3>+<2>+<ENT> the system will ask: “LOAD PROGRAM NO.:”
By pressing the required program number followed by <ENT>, the operating parameters saved
under the specified program number will be entered as the current parameters under the
respective functions.
At the same time, the following functions will be reset: F8 - F9 - F11 - F20 - F21.
If a calibration of the specific tube has been carried out, these parameters will also be loaded.
If program number 0 is selected, the function is left without loading a program and the system will
keep the current values.
6.7.27. Function 33 - Delete program
This function deletes the required program.
If a complete program is to be deleted, this can be done by overwriting it via Function 31, or the
program can be deleted via Function 33.
When entering <3>+<3>+<ENT> the system will ask for the program number to be deleted.
When pressing the required program number followed by <ENT> the specified program will be
deleted.
If a number is entered under which no program is saved, the system will not accept it and the
number must be corrected, or the function can be left by pressing <0>+<ENT>.