Westermo MR-200 - Manual (Page 14)

14 6615-2202
Step 4 – Connecting the serial cable
For connection to a serial terminal device, connect the 25-way D plug on the serial cable
provided to the SERIAL connector on the rear of the unit. Connect the other end of the
cable (9-way D socket) to the terminal. If the serial connector on the terminal is not a 9-
way D plug, you will need a suitable adapter.
Step 5 – Connecting the GPS antenna (if applicable)
If you have purchased the router with the GPS option fitted, this connector is used to
connect the GPS antenna. A range of suitable antennas are available for purchase sepa-
rately. To connect the antenna, screw the SMA termination firmly onto the rear panel
connector.
Step 6 – Connecting the power supply
Plug the jack plug on the mains adapter into the socket labelled 12VDC. When power is
first applied, the ON indicator will illuminate and the unit will initiate a series of diagnos-
tic self-tests. During this process one or more of the other indicators, will flash to show
that the unit is busy. When the flashing stops, the unit is ready to use.
The unit is now ready to be configured.