Eiki LC-XS25 - Manual (Page 48)

48
Setting
Logo select
This function decides the start-up display as follows:
User. . . . the image you captured
Default . . the factory-set logo
Off . . . . . countdown only
Logo (Logo and Logo PIN code lock settings)
This function allows you to customize the screen logo with
Logo select, Capture, and Logo PIN code lock functions.

Note:
When On is selected in Logo PIN code lock function,
Logo select and Capture functions cannot be
selected.
Logo select
Capture
This function enables you to capture the image being
projected and use it for a start-up display or interval of
presentations.
After capturing the projected image, go to the Logo
select function and set it to "User". Then the captured
image is displayed when turning on the projector next
time or pressing the NO SHOW button. (p.24)
To capture the image, select [Yes]. To cancel the
Capture function, select [No].

Notes:
• Before capturing an image, select Standard in the
Image Select Menu to capture a proper image.
(pp.31-32, 40-41)
• A signal from a computer can be captured up to
XGA (1024x768). A signal from video equipment
can be captured except for 720p, 1035i, and
1080i.
• When capturing the image that has been adjusted
by the Keystone function, the adjustment data is
automatically reset and the projector captures an
image without keystone adjustment.
• When the Logo PIN code lock function is "On",
Capture menu cannot be selected.
• When starting to capture a new image, the
previously stored image is cleared even if you
cancel the capturing.
• "User" cannot be selected when the image is not
captured.
Select [Yes] to capture
the projected image.
S e l e c t [ Ye s ] t o
stop capturing.
Capture
Setting