Eiki LC-XS25 - Manual (Page 54)

54
Setting
To Enter the PIN code
Select a number by pressing the Point ▲▼ buttons. And
then press the Point ► button to fix the number and move
the pointer. The number changes to " ". If you fixed
an incorrect number, move the pointer to the number
you want to correct by pressing the Point
◄ button, and
then select the correct number by pressing the Point ▲▼
buttons.
Repeat this step to complete entering a four-digit number.
After entering the four-digit number, move the pointer to
"Set" by pressing the Point
► button. Press the SELECT
button so that you can change the following PIN code lock
settings.
If you entered an incorrect PIN code, "PIN code" and the
number (
) turns red. Enter a correct PIN code all
over again.
The PIN code can be changed to your desired four-digit
number.
Select "PIN code change" with the Point ▼ button, and
press the SELECT button to display the New PIN code
input dialog box.
Select a number by pressing the Point ▲▼ buttons. And
then press the Point ► button to fix the number and move
the pointer. Repeat it to complete entering a four-digit
number. After entering the four-digit number, move the
pointer to "Set" by pressing the Point
► button. Then press
the SELECT button.
To Change the PIN code
CAUTION:
WHEN yOU HAVE CHANGED THE PIN CODE, WRITE
DOWN THE NEW PIN CODE IN COLUMN OF THE
PIN CODE NO . MEMO ON PAGE 7, AND KEEP IT
SECURELy . IF yOU FORGET yOUR PIN CODE, THE
PROjECTOR CAN NO LONGER BE STARTED .
Select Off, On1, or On2 with the Point ◄► buttons and
then move the red frame pointer to "Quit" with the Point ▼
button. Press the SELECT button to close the dialog box.
To Change the PIN code lock setting
Change the PIN code
S e l e c t P I N c o d e c h a n g e a n d
press the SELECT button. The
New PIN code input dialog box
appears.
T h e i n p u t n u m b e r s a r e b e i n g
displayed for confirmation.
Change the PIN code lock setting
Select a desired setting with the
Point
◄► buttons.
Enter a PIN code
The input numbers change
to "

" for security.
Move the pointer to "Set" by pressing
the Point
► button. And then press
the SELECT button.