Setting – Eiki LC-XS25 User Manual

Page 50

Advertising
background image

50

Setting

Ceiling

When this function is "On", the picture is top/bottom and
left/right reversed. This function is used to project the
image from a ceiling mounting the projector.

Rear

When this function is "On", the picture is left/right reversed.
This function is used to project the image to a rear
projection screen.

Ceiling

Rear

Standby mode

This function is available when the projector is turned off
and in Stand-by. It is recommended to use Eco under
normal condition.

Normal . . . . . . . . . . n o r m a l p o w e r c o n s u m p t i o n i n

Stand-by condition.

Eco. . . . . . . . . . . . . lower power consumption than

Normal mode in Stand-by condition.

Power management

For reducing power consumption as well as maintaining
the lamp life, the Power management function turns off the
projection lamp when the projector is not used for a certain
period.
When the input signal is interrupted and no button is
pressed for more than 30 seconds, the timer display with
"No signal" appears. The countdown starts to turn off the
lamp.

Select one of the operations:

Ready. . . . . . . . When the lamp has been fully cooled

down, the POWER indicator changes
to green blinking. In this condition, the
projection lamp is turned on if the input
signal is reconnected or any button
on the top control or remote control is
pressed.

Shut down . . . . When the lamp has been fully cooled

down, the power is turned off.

Off . . . . . . . . . . Power management function is off.

Then set the countdown timer with the Point

◄►

buttons.

Time left before Lamp is off.

Press the SELECT button
at Power management
and this box appears.
C h o o s e o n e o f t h r e e
settings with the Point

buttons, and go to the

timer with the Point

▲▼

buttons and set time with
the Point

◄►

buttons.

Power management

Note:

Factory default is " Ready, 5 min".

Advertising