AEC VacTrac Series Conveying Systems - Manual (Page 60)

Page 60 VacTrac™ Series Conveying Systems
WH2-605A.4 Mechanical Components
3-22 Installing the Powder Check Adapter
The powder check adapter is usually factory-installed. When
installing the powder check adapter, make sure you install it on the
tube stub as shown below. Remove the filter on the take-off
compartment and install the adapter using the four screws
provided, then replace the filter. No other adjustments are required.
Figure 26
Typical Powder Check Adapter
Customer horizontal
1/2" X 3/16"
take-off compartment
(13 mm x 4 mm) gasket
Internal check
valve
Filter