Airaid 200-280 User Manual
Page 2
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
REV.05.27.14
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
12. ) Install the 3/8” Breather Hose (#7) onto the
Barbed Fitting and factory hard line.
13. Install the Airaid Premium filter (#1) onto the Filter
Adapter , and tighten the hose clamp. Reconnect the
MAF And MAP sensors . . Install the Weather Strip
(#8) onto the Airaid Cold Air Box. (Hint: Start from one
corner and work your way around for ease of install.)
14. Reinstall the engine cover. Double check your work!
Make sure there is no foreign material in the intake path.
Make sure all clamps, hoses, bolts, and screws are tight.
Double check the hood clearance.
Reconnect the negative battery cable
A
First
Second
11. Install the Airaid Intake Tube assembly onto the
Filter Adapter first, and then onto the throttlebody. Ad-
just for fit, and tighten all hose clamps. Reinstall the
hose anchor into the Airaid Intake Tube.
10. A.) Install the 3/8 NPT Fitting (#14) in to the Airaid
Intake Tube.
B.) Install the Hump Hose (#5), Coupler (#6) and Hose
Clamps (#13) on to the Intake Tube as shown. Leave
the clamps loose for now.
B
WARNING! If your vehicle has a Vehicle Emission Control Information decal affixed to the factory airbox, a
new replacement label must be obtained and installed in a readily visible position in the engine compartment in
order to remain CARB compliant. Failure to do so will prevent the vehicle from passing a smog check. Replace-
ment labels can be ordered from your local dealership. Regulations state that the VECI label shall not be affixed
to any equipment which is easily detached from the vehicle. Label placement, under the hood on a painted sur-
face is recommended.
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.
FILTER IDENTIFICATION
720-472 Airaid Oiled Media 721-472 Airaid SynthaMax Dry Media - Red
722-472 Airaid SynthaMax Dry Media - Black 723-472 Airaid SynthaMax Dry Media - Blue
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!
Synthamax Air Filters do not require oil.
Service air filter as needed by cleaning
with common non-petroleum all-purpose
household cleaner and water. Simple
Green®, Formula 409® or equivalent
works great. Apply cleaner to outside of
air filter and allow to soak. Then flush
filter clean from the inside out with a gar-
den hose and repeat steps if necessary.
Do not apply high pressure water or air
to clean filter. Allow filter to air dry and
reinstall
.
9. Install the CAB ( #3) into the engine compartment
and secure using three of the tray bolts from step 6.
B
B