Filter identification – Airaid 350-318 User Manual
Page 2
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.
13. Insert the Intake Tube assembly into the Hump Hose
first, then into the Coupler onto the throttle body. Tight-
en all four Clamps at this time,
10. Insert the Barbed Fitting into the supplied PCV Hose
and connect it to the Elbow in the Intake Tube. Use the
Speed Clamps to secure the Hose onto the Fittings.
11. Slide the Hump Hose and the # 72 Clamps onto the
Filter Adapter. Leave the Clamps loose for now.
12. Slide the Reducing Coupler and the # 56 and 64
Clamps onto the throttle body. Leave the Clamps loose
for now.
REV.01.13.15
14. Reconnect the air temperature sensor.
15. Connect the Barbed Fitting in the PCV hose to
crank case breather line in the valve cover .
FILTER IDENTIFICATION
720-127 Airaid Oiled Media 721-127 Airaid SynthaMax Dry Media - Red
722-127 Airaid SynthaMax Dry Media - Black 723-127 Airaid SynthaMax Dry Media - Blue
Synthamax Air Filters do not require oil.
Service air filter as needed by cleaning
with common non-petroleum all-purpose
household cleaner and water. Simple
Green®, Formula 409® or equivalent
works great. Apply cleaner to outside of
air filter and allow to soak. Then flush
filter clean from the inside out with a gar-
den hose and repeat steps if necessary.
Do not apply high pressure water or air
to clean filter. Allow filter to air dry and
reinstall.
For your Oiled media filter
we suggest using the AIRAID
Filter Tune-Up Kit!
16. Install the Airaid Premium Filter onto the Filter
Adapter.
17. Install the Weatherstrip onto the top edge of the Air
Box with the contour rolling away from the Filter.
18. Reinstall the engine cover and oil cap. Reconnect
the negative terminal on the battery.
Speed Clamps
Barbed Fitting
#64Clamp
#56 Clamp
19. Double check your work.
Make sure there is no foreign material in the intake path. Make sure all clamps, hoses, bolts, and screws are tight. Double check the hood clearance!