Extron Electronics Extender Series - Manual (Page 27)

Extender Series • Installation 2-17
PRELIMINAR
Y
Mounting the Extender WM, Extender WM AAP, or
Extender WM AUS to the wall box
1 . Remove power from the line driver by disconnecting the
power supply.
2 . Place the line driver through the opening in the wall or
furniture and into the wall box. Take care not to damage
the output cables, which fit behind the line driver at the
back of the wall box.
3 . Mount the line driver’s faceplate to the wall box with
machine screws as shown in the following illustration.
Extender WM AAP Install.eps
Installation
Cable
Cable Clamp
Wall Stud
Screws or Nails
Extender WM AAP
EX TEN
DE R W M A
AP
CO
MP UT ER IN
AUD
IO I N
Mounting the line driver to the wall box
4 . Reconnect the power supply and restore power to the
equipment.