Pin setup, Address list, Reset – Alinco DR-138 User Manual
Page 31
23
8
PIN Setup(
Useless if PIN is not assigned
)
Enable this function, you have to insert a matching PIN to enter into
normal status when radio is turned on.(The PIN can be assigend by
programming software only.)
Press and hold
1.
key for over 2
seconds to enter setting menu.
Press
2.
/
key to choose No.27
menu, LCD displays "
CODE-OF".
Turn Main Dial to enable/disable Pin
3.
setup.
ON: Turn on Pin setup
OFF:Turn off Pin setup
Press
4.
key to confirm and exit.
This function may not be available in dealer-programmed units.
General Setting
Address list
You store desired ID and corresponding ID name in address list. The
LCD displays ID corresponding name if radio received ANI calling and
find matching ID in address list.
RESET (
May be blocked for dealer-programmed units
)
If your radio seems to be malfunctioning, resetting the microprocessor
may solve the problem. When performing the reset, you may lose
memory data and stored information. Back up or write down important
data before performing the reset.
Press and hold
1.
key for over 2 seconds to enter general setting
menu.
Press
2.
/
key to choose No.28
menu, LCD displays "
BOOK".
Press
3.
to enter into ID setting, press
/
to select the desired group (00-
127, total is 128 group ID). Turn Main
Dial to select desired number, press
confirm and move cursor
Press and hold
1.
key for over 2
seconds to enter general setting menu.
Press
2.
/
key to choose No.29
menu, LCD displays "
RESTORE".
Turn Main Dial to select the desired
3.
operation.
FACT:Resume factory default for
channel, signaling and general setting.
SETUP:Return initial setup for No.18-No.27 general setting menu.
Press
4.
key to perform the reset.
to next edition, press
to clear out all
digits.
After finishing edition, press to confirm
4.
and enter into edition of current group's ID corresponding name.
Turn selector knob to select desired letter, press
to move
cursor to next edition, press
to clear out all letters. 00-127,
total 128 group ID and corresponding ID name.
Press
5.
to confirm and return into main menu. Repeat above
Step 3 and Step 4 operations to edit multi-ID and corresponding ID
name.
Press
6.
key to return to standby status.