Allmand Brothers ML6-8 LD - Manual (Page 26)

26
ROUTINE MAINTENANCE SCHEDULE
LISTER-PETTER LPW-3 INSPECTION AND LUBRICATION SCHEDULE
Check condition of the steel cable and make sure it is properly secured. Check hydraulic fluid
level.
Lubrication grease specifications: N.G.L.I. consistency #2, high temperature anti-friction
bearing lubricating grease.
Service intervals shown below have been established for operation under normal conditions.
Where equipment is operated under severe conditions (very dusty, extreme heat or cold, etc.)
affected items should be serviced more frequently.
INTERVAL ITEM PROCEDURE
Fuel level Check and fill as necessary.
Lubricating oil Check level and condition. Daily or 10 Hr.
Air Cleaner Clean under very dusty conditions.
All 10 Hr. items As above
Air Cleaner
Change element if necessary or clean
under moderately dusty conditions.
Battery Check level of electrolyte.
125 Hr.
Engine Generator assembly Check for fuel and lubricating oil leaks.
All 125 Hr. items As above
Engine lubricating oil
system
Drain lubricating oil, flush out system,
renew filter element and refill with correct
grade and type oil.
Fuel Injector Nozzles Clean if the exhaust is dirty
250 Hr.
Fuel Filter
Renew filter element if fuel not perfectly
clean.
All 250 Hr. Items As above
500 Hr.
Fuel Filter Renew filter element.
All 500 Hr. Items As above
Engine Service
Decarbonize if the engine shows loss of
compression or blow-by past the piston.
Do not disturb otherwise.
Engine Valves Adjust clearance.
Engine Service
Clean the cylinder and cylinder head
finning under dusty conditions if necessary.
Cable pulley at the bottom
of the front mast support
Remove, clean, and grease.
Cable pulleys on mast Inspect for wear. Clean and lubricate.
Axle wheel bearings Clean and repack.
1000 hr. or yearly
Fuel System Clean sediment from tank.