Amer Networks MR16 - Manual (Page 15)

11
The chassis system is equipped with one power supply and
allows one additional power supply for redundancy. For
reliable operation, we suggest that you run the chassis
system with two power supplies are in place.
Step 1: Connect the supplied AC power cord to the back of the chassis.
Step 2: Attach the plug into a standard AC outlet with a voltage range
from 100~240Vac.
Step 3: Turn on the chassis system by flipping the switch beside the
receptacle to ON position. The LED on the front panel of power
supply will come on then.
.
Installing and Removing the Power Supply
z To remove a power supply out the chassis, you have to loose the
hand screw counter clockwise and pull out the power supply from
the chassis.
z To install a power supply to the chassis, you have to fasten the hand
screw clockwise and slide in the power supply to the chassis.
You can slide in and out the power supply from the bay,
fasten or loose the hand screw clockwise or counter
clockwise by using hand or screwdriver.
If the Chassis System needs to work alone, you can
stick up four Rubber foot below the chassis!
Attention!