ARAG Bravo 300s series computers crop spraying - Direct connection - INSTALLATION User Manual
Page 7
7
6.2
Monitor position
Bravo 300S must be placed in the control cabin of the farming machine. Observe the following
precautions:
- DO NOT install the monitor in areas where it would be subjected to excessive
vibrations or shocks, to prevent any damage or accidental use of the control keys;
- Install the device in a visible position within easy reach by hand; bear in mind that
the computer should not obstruct the operator’s freedom of movement or block his
view.
Consider all necessary connections of the computer (Fig. 4), the cable length, and make
sure there is enough space for connectors and cables.
An identification symbol is located next to each connector to indicate its function.
For any reference to the system configuration, read Par. 6.1 - System recommended
composition.
item
Monitor connection points
1
Control unit and sensors
2
Power supply
3
Auxiliary connections
4
SD memory card
6.3
Bracket fixing
The monitor must be mounted after having fixed the bracket at the desired location (the previous
paragraph shows the bracket drilling template).
The bracket must be slid out of the monitor seat (
A
, Fig. 5) and fixed using the supplied screws (
b
).
Make sure the bracket is securely mounted, fit the monitor on it, and push it until it locks in place (
c
).
Tab.1
Fig. 4
Fig. 5