ARAG ORION Visual Flow - Manual (Page 6)

6
3 SWITCH ON
When the flowmeter is turned on, after a diagnostic test, it displays the following information in
sequence:
• Software version;
• Unit of measurement;
• Indicator of data displayed.
4 PRELIMINARY SETUP FOR USE
4.1 Notes on programming
After having modified a parameter in the "OPT" Advanced menu, to return to the Main menu turn
the device off and then on again.
When you are modifying a parameter or are in a Menu other than the Main menu and you do not
press a key within 10 seconds, the display will automatically return to the Main menu.
When modifying a numerical value, keep the key pressed to enable quick modification.
4.2 "OPT" Advanced menu
Upon installation of the flowmeter in the filling system some settings are
needed to properly display the filling data:
• Operation mode
• Unit of measure
• Valve operation time
To access the Advanced menu, keep the key pressed while switching ON
the device until the "OPT" screen appears.
4.3 "MODE" Operation mode
It is possible to set three different operating modes:
MODE 0 = Tank filling count with pump stop control (0000 ÷ 9999 EU: l [predefined setting] - US: Gal).
MODE 1 = Flowrate display.
MODE 2 = Tank filling count with pump stop control (0 ÷ 999,9 EU: l - US: Gal).
1 2 3 4
Access the "OPT" Advanced menu as shown in Par. 4.2.
1) Press in succession to display the enabled operation mode; the value alternates with the message
"MODE".
2) To modify the value, keep the keys pressed simultaneously until
"SET" screen appears.
3) Press in succession to select the mode you wish to use.
4) To confirm the setting, keep the keys pressed simultaneously until
"SAVE" screen appears.
The display alternatively flashes the set operation mode and "MODE" screen.
Fig. 7
Fig. 6