Ericsson GH388/GF388 - Manual (Page 46)

4. Enter the new code. (You only need to enter
40 for code 040, since the phone will add
the leading zero automatically.)
To erase or replace a code
If you wish to erase a code or replace a code,
press YES when that specific code is shown in
the display. The question Erase? appears.
a. To erase the code, press YES.
b. To replace the code, press
R
, followed by
YES. Enter the new code and press YES.
An AI is only displayed once, unless its content
has changed. If you wish to have a message
repeated, you must first erase the code for that
message type and then enter the same code
again. The phone will see this as a new code
which is being entered and thus display the first
message available of that type.
Advanced Functions
46 EN/LZT 126 1298 R1A