Electrolux EKC60752 - Manual (Page 10)

9
Electrical connections
Any work required on the cooker must
be carried out by a
QUALIFIED EXPERT .
Any work carried out by non-qualified
people can mean poorer cooker
performance and result in personal
injury and/or damage to property.
The electrical installation is to include a
device whereby it is possible to separate all
the poles of the equipment from the power
supply, with a contact opening of at least
3 mm.
This requirement must be satisfied for
safety reasons.
The connected rating and voltage are
shown on the data plate. There is a wiring
diagram on the back of the cooker.
Decor plinth (optional accessory)
NOTE! Take due care when fitting
the base trim to the cooker. Edges
with which you do not normally come
into contact with can be sharp.
NOTE ! ONLY FITS COOKERS WITH A HEIGHT
OF 900 MM (35.5").
Remove the protective plastic before use.
1 Remove the drawer from the cooker by
lifting it diagonally upwards and then
pulling it all the way out.
2 Fit the base trim by pressing it firmly
onto the base (snap fastener, no tools
needed).
3 Re-fit the storage drawer.
Bild 5