H3C Technologies H3C S12500 Series Switches - Manual (Page 424)

408
Protocol: pim-dm, UpTime: 00:02:19, Expires: never
IPv6 PIM-SM non-scoped zone configuration example
Network requirements
Receivers receive VOD information through multicast. The receiver groups of different organizations form
stub networks, and one or more receiver hosts exist in each stub network. The entire PIM domain is
operating in the sparse mode.
Host A and Host C are IPv6 multicast receivers in two stub networks N1 and N2.
VLAN-interface 105 on Switch D and VLAN-interface 102 on Switch E act as C-BSRs and C-RPs; the
C-BSR on Switch E has a higher priority; the IPv6 multicast group range to which the C-RP is designated
is FF0E::101/64; modify the hash mask length to map a certain number of consecutive IPv6 group
addresses within the range to the two C-RPs.
MLDv1 runs between Switch A and N1 and between Switch B/Switch C and N2.
Figure 110 Network diagram
Table 28 shows the interface and IPv6 address assignment, and network topology scheme.
Table 28 Interface and IPv6 address assignment
Device Interface IPv6 address
Switch A VLAN-interface 100 1001::1/64
Switch A VLAN-interface 101 1002::1/64
Switch A VLAN-interface 102 1003::1/64
Switch B VLAN-interface 200 2001::1/64
Ether
net
Ethern
et
Ether
net
N1
N2
Vlan-
int
101
Vlan-
int10
1