H3C Technologies H3C S12500 Series Switches - Manual (Page 464)

448
Figure 113 Network diagram
Device Interface IP address Device Interface IP address
Source N/A 1002::100/64 Switch C Vlan-int200 3002::1/64
Switch A Vlan-int100 1002::1/64 Vlan-int102 2001::2/64
Vlan-int101 1001::1/64 Vlan-int104 3001::1/64
Switch B Vlan-int101 1001::2/64 Switch D Vlan-int103 2002::2/64
Vlan-int102 2001::1/64 Vlan-int104 3001::2/64
Vlan-int103 2002::1/64
Configuration procedure
1. Configure IPv6 addresses for interfaces as shown in Figure 113 . (Details not shown.)
2. Configure OSPFv3. (Details not shown.)
3. Enable IPv6 multicast routing, IPv6 PIM-SM, and MLD, and configure an IPv6 PIM-SM domain
border:
# Enable IPv6 multicast routing on Switch A, and enable IPv6 PIM-SM on each interface.
<SwitchA> system-view
[SwitchA] multicast ipv6 routing-enable
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] pim ipv6 sm
[SwitchA-Vlan-interface100] quit
[SwitchA] interface vlan-interface 101
[SwitchA-Vlan-interface101] pim ipv6 sm
[SwitchA-Vlan-interface101] quit
# Enable IPv6 multicast routing on Switch B and Switch D in the same way, and enable PIM-SM on
each interface.
# Enable IPv6 multicast routing on Switch C, enable IPv6 PIM-SM on each interface, and enable
MLD on the host-side interface VLAN-interface 200.
<SwitchC> system-view
[SwitchC] multicast ipv6 routing-enable
[SwitchC] interface vlan-interface 102
[SwitchC-Vlan-interface102] pim ipv6 sm
[SwitchC-Vlan-interface102] quit
V
la
n-i
nt1
02
V
la
n-
in
t1
03
V
la
n-
in
t1
03 V
la
n-i
nt1
02
V
la
n-
in
t2
00