H3C Technologies H3C S10500 Series Switches - Manual (Page 37)

29
4. Connect the fiber to the module. For the installation procedure, see " Connecting your switch to the
network ."
Figure 26 Installing an XFP/SFP+/SFP/QSFP+ module
Installing a CFP module
1. Wear an ESD wrist strap and make sure it makes good skin contact and is well grounded. For
more information, see "
Attaching an ESD wrist strap ."
2. Unpack the CFP module. Do not touch the golden finger of the module.
3. Holding both sides of the module, gently push the module into the slot until it has firm contact with
the slot. See
Figure 27 .
4. Fasten the captive screws.
5. Connect the fiber to the module. For the installation procedure, see " Connecting your switch to the
network ."
Figure 27 Installing a CFP module
(1) Gently push the module into the slot (2) Fasten the captive screws
Connecting an SFP+/QSFP+/QSFP+ to SFP+ cable
Use SFP+ cables to connect SFP+ ports, QSFP+ cables to connect QSFP+ ports, and QSFP+ to SFP+
cables to connect QSFP+ and SFP+ ports. All these cables are hot swappable.
To connect an SFP+, QSFP+, or QSFP+ to SFP+ cable: