Appendix b frus and compatibility matrixes, Mpus, Lpus – H3C Technologies H3C S10500 Series Switches User Manual
Page 73: Appendix b frus and, Compatibility matrixes, N, see
65
Appendix B FRUs and compatibility matrixes
This appendix describes the field replaceable units (FRUs) available for the S10500 switch series and
their compatibility.
All the FRUs in this appendix are hot swappable.
MPUs
CAUTION:
Use the Comware V5 software (with the version number R1XXX) for the LSU1SUPA0. Use the Comware
V7 software (with the version number R2XXX) for the LSU1SUPB0.
MPU is the core of the control management plane for the switch. The switch series supports the MPUs
LSU1SUPA0 (LSUM1SUPA0) and LSU1SUPB0 (LSUM1SUPB0). They are applicable to all S10500 switch
models. MPUs are ordered separately. An S10500 switch requires one MPU to operate correctly. You
can also install two MPUs of the same model for redundancy.
Table 18 MPU supervisor engine specifications
Item Description
Interfaces
•
One console port for local or remote dialup configuration management
•
One 10/100/1000BASE-T interface for management and upgrade
Interface transmission
rate
•
Console port—No greater than 115200 bps and defaults to 9600 bps
•
10/100/1000BASE-T interface—10/100/1000 Mbps
Cables and max
transmission distance
•
Console port—15 m (49.21 ft) over common asynchronous serial interface cable
•
10/100/1000BASE-T interface—100 m (328.08 ft) over Category-5 twisted
pairs
LPUs
apply to all S10500 switches. For more information about the transceiver modules
that each LPU supports, see "
NOTE:
The model of a card is LSUM-prefixed on the card package and LSU-prefixed on the card panel. For
example, LSU1TGS16SC0 and LSUM1TGS16SC0 identify the same card. When you order a card, refer
to the card by its LSUM-prefixed model. In this chapter, the card models are LSU-prefixed, the same as
marked on the card panels.