H3C Technologies H3C S10500 Series Switches - Manual (Page 70)

59
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter VSAN view. vsan vsan-id N/A
3. Configure a static FC
route.
fc route-static fcid { mask | mask-length }
interface-type interface-number [ cost
cost-value ]
By default, no static FC route exists.
Configuring FSPF
FSPF is enabled by default. Typically, you do not need to perform special operations.
You can change FSPF parameters on a per-VSAN or per-interface basis.
FSPF configuration task list
Tasks at a glance Remarks
Change FSPF parameters in VSAN view
• (Required.) Enabling FSPF
• (Optional.) Setting the shortest SPF calculation interval
• (Optional.) Setting the minimum LSR arrival interval
• (Optional.) Setting the minimum LSR refresh interval
N/A
(Optional.) Change FSPF parameters in interface view
• Setting the FSPF cost for an interface
• Setting the hello interval for an interface
• Setting the dead interval for an interface
• Setting the LSR retransmission interval for an interface
• Disabling FSPF for an interface
Configure parameters on interfaces
operating in E mode.
(Optional.) Configuring FSPF GR
• Configuring the GR restarter
• Configuring the GR helper
N/A
Enabling FSPF
FSPF-related features can work in a VSAN only after you enable FSPF for the VSAN.
To enable FSPF:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter VSAN view. vsan vsan-id N/A
3. Enable FSPF for the VSAN. fspf enable
By default, FSPF is enabled after a VSAN is
created.